B3LYP is the most famous hybrid density functional theory model, which includes Hartree–Fock exchange, local exchange, gradient exchange correction, local correlation, and gradient correlation correction. Historically, the relative weight of each component in B3LYP, which is controlled by three empirical parameters ( a 0 , a x , a c ), has not been optimized. In this work, we perform global optimization against accurate experimental reference, optimal empirical parameters, and the better version of B3LYP are obtained and denoted as OpB3LYP. The performance of OpB3LYP is widely tested over many species and chemical properties, the results show that the computational accuracy is significantly improved as compared to original B3LYP and the serious size dependence of B3LYP is remarkably overcome by the employment of OpB3LYP. The comparative assessment of OpB3LYP and other prevalent functionals indicates that OpB3LYP is a promising functional for large molecules. © 2015 Wiley Periodicals, Inc.

Accurate exchange-correlation (XC) potentials for three-dimensional systems─via solution of the inverse density functional theory (DFT) problem─are now available to test the quality of DFT approximations. Herein, the exact XC potential for seven molecules─dihydrogen at four different bond-lengths, lithium hydride, water, and ortho-benzyne─are computed from full configuration interaction reference densities. These are compared to model XC potentials from nonlocal (B3LYP, HSE06, SCAN0, and M08-HX) and semilocal/local (SCAN, PBE, and PW92) XC functionals. Whereas for most systems, relative errors in the ground-state densities are O(10-3-10-2), the model XC potentials have much higher errors of O(10-1-100). Among the model XC functionals, SCAN0 offers the best agreement with the exact XC potential, underlining the significance of satisfying exact conditions as well as including nonlocal effects in XC functionals. This work indicates that tests against the exact XC potential will provide a promising new direction for building more accurate XC functionals for DFT.

The performance of three density functional theory (DFT) exchange-correlation functionals, namely, Perdew-Burke-Ernzerhof (PBE), BP86, and B3LYP, in predicting conformational distributions of a hydrated glycine peptide is tested with two different basis sets in the framework of adaptive force matching (AFM). The conformational distributions yielded the free energy profiles of the DFT functional and basis set combinations. Unlike traditional validations of potential energy and structural parameters, our approach allows the free energy of DFT to be validated. When compared to experimental distributions, the def2-TZVP basis set provides better agreement than a slightly trimmed aug-cc-pVDZ basis set. B3LYP is shown to be better than BP86 and PBE. The glycine model fitted against B3LYP-D3(BJ) with the def2-TZVP basis set is the most accurate and named the AFM2021 model for glycine. The AFM2021 glycine model provides better agreement with experimental J-coupling constants than C36m and ff14SB, although the margin is very small when compared to C36m. Our previously published alanine model is also refitted with the slightly simplified AFM2021 energy expression. This work shows good promise of AFM for developing force fields for a range of proteinogenic peptides using only DFT as reference.

Abstract The central‐zone vibrational spectrum of α‐quartz (SiO 2 ) is calculated by building the Hessian matrix numerically from the analytical gradients of the energy with respect to the atomic coordinates. The nonanalytical part is obtained with a finite field supercell approach for the high‐frequency dielectric constant and a Wannier function scheme for the evaluation of Born charges. The results obtained with four different Hamiltonians, namely Hartree–Fock, DFT in its local (LDA) and nonlocal gradient corrected (PBE) approximation, and hybrid B3LYP, are discussed, showing that B3LYP performs far better than LDA and PBE, which in turn provide better results than HF, as the mean absolute difference from experimental frequencies is 6, 18, 21, and 44 cm −1 , respectively, when a split valence basis set containing two sets of polarization functions is used. For the LDA results, comparison is possible with previous calculations based on the Density Functional Perturbation Theory and usage of a plane‐wave basis set. The effects associated with the use of basis sets of increasing size are also investigated. It turns out that a split valence plus a single set of d polarization functions provides frequencies that differ from the ones obtained with a double set of d functions and a set of f functions on all atoms by on average less than 5 cm −1 . © 2004 Wiley Periodicals, Inc. J Comput Chem 25: 1873–1881, 2004

We investigate the binding of single and quadruple hydrogen molecules on a positively charged Ca ion. By comparing with benchmark quantum Monte Carlo (QMC) calculations we demonstrate wide variability in other more approximate electronic structure methods including common density functionals. Single determinant QMC calculations find no binding at short range by approximately 0.1 eV for the quadruple hydrogen molecule case, for a fixed hydrogen bond length of 0.77 Angstrom. Density functional calculations using common functionals such a LDA and B3LYP differ substantially from the QMC binding curve. We show that use of full Hartree-Fock exchange and PBE correlation(HFX+PBEC) obtains close agreement with the QMC results, both qualitatively and quantitatively. These results both motivate the use and development of improved functionals and indicate that caution is required applying electronic structure methods to weakly bound systems such as hydrogen storage materials based on metal ion decorated nanostructures.

We investigate the binding of single and quadruple hydrogen molecules on a positively charged Ca ion. By comparing with benchmark quantum Monte Carlo (QMC) calculations we demonstrate wide variability in other more approximate electronic structure methods including common density functionals. Single determinant QMC calculations find no binding at short range by approximately 0.1 eV for the quadruple hydrogen molecule case, for a fixed hydrogen bond length of 0.77 Angstrom. Density functional calculations using common functionals such a LDA and B3LYP differ substantially from the QMC binding curve. We show that use of full Hartree-Fock exchange and PBE correlation(HFX+PBEC) obtains close agreement with the QMC results, both qualitatively and quantitatively. These results both motivate the use and development of improved functionals and indicate that caution is required applying electronic structure methods to weakly bound systems such as hydrogen storage materials based on metal ion decorated nanostructures.

Density functional theory and DFT+U study of transition metal porphines adsorbed on Au(111) surfaces and effects of applied electric fields We apply Density Functional Theory (DFT) and the DFT+U technique to study the adsorption of transition metal porphine molecules on atomistically flat Au(111) surfaces. DFT calculations using the Perdew-Burke-Ernzerhof (PBE) exchange correlation functional correctly predict the palladium porphine (PdP) low-spin ground state. PdP is found to adsorb preferentially on gold in a flat geometry, not in an edgewise geometry, in qualitative agreement with experiments on substituted porphyrins. It exhibits no covalent bonding to Au(111), and the binding energy is a small fraction of an eV. The DFT+U technique, parameterized to B3LYP predicted spin state ordering of the Mn d-electrons, is found to be crucial for reproducing the correct magnetic moment and geometry of the isolated manganese porphine (MnP) molecule. Adsorption of Mn(II)P on Au(111) substantially alters the Mn ion spin state. Its interaction with the gold substrate is stronger and more site-specific than PdP.

Electronic and magnetic properties of a hexanuclear ferric wheel The electronic and magnetic properties of the hexanuclear ferric wheel [LiFe6(OCH3)12-(dbm)6]PF6 have been studied with all-electron Hartree-Fock and full-potential density functional calculations. The best agreement for the magnetic exchange coupling is at the level of the B3LYP hybrid functional. Surprisingly, the Hartree-Fock approximation gives the wrong sign for the exchange coupling. The local density approximation and the gradient corrected functional PBE strongly overestimate the exchange coupling due to the too large delocalization of the d-orbitals. These findings are supported by results from the Mulliken population analysis for the magnetic moments and the charge on the individual atoms. Published as: Eur. Phys. J. B 44, 209-215 (2005) DOI: 10.1140/epjb/e2005-00116-5 arXiv categories: cond-mat.other